SoundMax SM-MSD10 - Manual (Page 9)

9
Connection
Before you start connection of external devices, ensure that power of the unit is switched off. Following outputs are
available in this unit:
Composite video
Use the yellow plug of an AV cable to connect the composite video output of this unit to the video input of a TV/monitor.
Component video
Use a 3-core AV cable to connect the component outputs of this unit to the corresponding inputs of a TV/monitor.
S-Video
Use an S-Video cable to connect the S-Video output of this unit to the S-Video input of a TV/monitor.
SCART
Use a 21-pin SCART cable to connect the SCART output of this unit to the TV/monitor SCART input.
Stereo audio
Use a pair of RCA cables (red for right/white for left) to connect the stereo audio outputs of this unit to a TV or a stereo
input of power amplifier.
Coaxial digital audio
Use the special coaxial cable to connect the coaxial output of this unit to the coaxial input of power amplifier.
Speaker output
Use the built-in cable of the speakers to connect this unit to the input of sound boxes.
Line in
Use RCA cables (red for right/white for left) to connect the stereo audio inputs of this unit to a stereo output of external
devices such as DVD/VCD/VCR player etc., to obtain analog audio signal from the external device.
Notes:
The connection you should make depends on the TV/monitor input terminals. Don’t make all the connections at the
same time; otherwise the produced picture will be affected.
The physical connection should accord to the audio output setup of this unit.
The unit does not support DTS sound output. To obtain DTS format sound you need to connect the unit to an external
amplifier supporting DTS with the help of a coaxial cable (not included).