Swarovski Optik EL Range - Manual (Page 12)

23
DE
22
DE EN EN
b. once you have finished, push the dioptric adjustment rings
back in.
3.4. Dioptric compensation
to achieve optimal image quality, it is necessary to correct
any varying visual acuity between the left and right eye.
1. First pull out the left dioptric adjustment ring.
2. turn the dioptric adjustment ring anticlockwise until it
stops.
3. Hold down the mode button for 4 seconds. this takes you
to the dioptric compensation adjustment mode (display
remains illuminated for 30 seconds). to exit this mode
early, press the measurement button or mode button
again.
4. Now look through the left eyepiece at the display with your
left eye and slowly turn the dioptric adjustment ring clock-
wise until the display comes into clear focus.
5. once you have finished, push the dioptric adjustment ring
back in.
6. Repeat steps 1 to 5 with the right dioptric adjustment
ring to optimally adjust the focus for the right eye (aiming
mark).
NotE:
Setting the twist-in eyecups and eye relief precisely helps to
ensure maximum viewing comfort for the display (see chapter
3.1. and 3.2.).
tIp:
the aiming mark and range indication can be set comfortably
even without a target. Place the binoculars on a table upright
or look at a nearby dark object. Adjusting each dioptric
position separately allows you to achieve optimum sharpness
because your eye is not distracted by a target under obser-
vation.
3.5. adjusting the focus
to adjust your object focus from the
shortest focusing distance (see tech-
nical Data Sheet) to infinity, simply
turn the focusing wheel. In the infinity
position, the wide bar on the focusing
wheel points upward.