TIMBERK THU UL 03 series - Manual (Page 3)

The humidifier should be installed on a rise e.g. on a table, pedestal,
etc.
Never fill the water in the humidifier through a diffuser.
Do not immerse the humidifier in water or other liquids.
Do not install the humidifier in a passage or in other places, where it can
be touched, overturned, etc.
If the humidifier is not in use, unplug it. Do not lay a power cable under
a carpet or other objects. While placing the humidifier, be careful that
you do not touch the power cable by accident. Do not use the
humidifier in damp rooms.
Prevent the ingress of foreign objects into the humidifier.
Do not block an air intake and the diffuser with foreign objects.
Do not sit or stand on the humidifier and do not put heavy objects on it.
To avoid the damage of the humidifier, do not mix the water used for
humidification with essential oils, preservation agents, flavouring
materials and other foreign substances. The manufacturer and vendor
are not responsible for damages of the humidifier caused by
nonfulfillment of this requirement.
While unplugging the humidifier, do not pull the power cable and do
not touch it with wet hands.
3. Specification
Table 1.
280
220/50
3,3
38
0,17
Ipx0
ll
220 220 325
250 250 360
2,0
2,4
20-30
Humidification capacity, ml/h
Supply voltage, V/Hz
Tank volume, l
Power consumption, W
Nominal current, A
Moisture protection class rating
Electrical protection class rating
Appliance dimensions, mm
Package dimensions, mm
Net weight, kg
Gross weight, kg
Recommended floor space, m
3 www.timberk.com electric humidifier
ENGLISH
4. Appliance description
1.Diffuser*
2.Water tank knob
.Water tank
4.Cover of water tank with flap
5.Base
6.Ventilation hole
7.Ultrasonic membrane
8.Safety switch for the lack of water
9.Power cord and plug
10.Indication light
11.On-and-off and steam escape intensity controller
12.Chamber of aromatic oil
13.Water filter
* The diffuser spins a full 360°, the direction of steam diffusion is controlled
manually at user's will
13
2
The manufacturer reserves the right to change the set-list of the device (including liquid and powder
components) for different supplies without prior notice. The changes either in no way influence the
basic technical parameters of the device or may improve them, and also not violate the legislation or
quality standards of the countries of manufacture, transit and selling.
The changes in the set-list may result in changing of the weight and dimensions of the device, but not
more than by +\- 5-20% (depending on the product category)