HONDA 2011 Civic Coupe - Manual (Page 309)

Remove the oil filter, and let the
remaining oil drain. A special
wrench (available from your
dealer) is required.
Refill the engine with the
recommended oil.
Engine oil change capacity
(including filter):
Let the engine run for several
minutes, then check the drain bolt
and oil filter for leaks.
Install a new oil filter according to
the instructions that come with it.
Make sure to clean off any dirt
and dust on the contacting surface
of a new oil filter.
Put a new washer on the drain bolt,
then reinstall the drain bolt.
Tighten the drain bolt to:
Make sure the oil filter gasket is
not stuck to the contacting surface
of the engine. If it is, remove it
before installing a new oil filter.
Reinstall the engine oil fill cap.
Start the engine. The oil pressure
indicator should go out within 5
seconds. If it does not, turn off the
engine, and check your work.
5.
6.
7.
8.
3. 4.
Si
DX, DX-G, LX, SE, EX, EX-L
CONTINUED
Changing the Engine Oil and Filter
Ma
int
e
na
nce
303
OIL FILTER
Si
OIL
FILTER
DX, DX-G, LX, SE, EX, EX-L
3.9 US qt (3.7 )
29 lbf·ft (39 N·m , 4.0 kgf·m)
4.6 US qt (4.4 )
10/06/24 17:01:27 31SVA650_308