HONDA 2010 Ridgeline - Manual (Page 47)

To install a LATCH-compatible child
seat:
Make sure there are no objects
near the anchors that could
prevent a secure connection
between the child seat and the
anchors.
When using the tether strap on
the child seat, attach the tether
strap hook to the center tether
anchor before installing the child
seat to the lower anchors for the
LATCH system, because the
center tether anchor is positioned
behind the child seat.
If needed, move the seat belt
buckle or tongue away from the
lower anchors.
Whenever using the center tether
anchor point, make sure to push
down the head restraint to the lowest
position, route the strap over the
seat-back, then around the upper
guide before attaching the tether
strap hook to the center tether
anchor (see page
).
The location of each lower anchor is
indicated by a small button above the
anchor point.
The lower anchors are located
between the seat-back and seat
bottom, and are to be used only with
a child seat designed for use with
LATCH.
Your vehicle is equipped with
LATCH (Lower Anchors and
Tethers for CHildren) at the rear
seats.
1.
2.
3.
48
CONTINUED
On the center seating position
Installing a Child Seat
Installing a Child Seat with
LATCH
Dr
iv
er
and
P
asseng
er
Saf
e
ty
43
BUTTON UPPER GUIDE
CENTER TETHER ANCHOR
LATCH
ANCHOR
POINTS
09/07/18 14:04:53 31SJC640_048
2010 Ridgeline