JVC KD-DV4402 - Manual (Page 12)

ENGLISH
12
Activating/deactivating TA/PTY Standby Reception
TA Standby Reception Indicator PTY Standby Reception Indicator
Press to activate. See page 25.
The unit temporarily will switch to Traffic
Announcement (TA), if available, from any
source other than AM.
The volume changes to the preset TA
volume level if the current level is lower
than the preset level (see page 25). Lights up The unit temporarily will switch to your
favorite PTY programme from any source
other than AM. Lights up
Not yet activated. Tune in to another
station providing the RDS signals. Flashes Not yet activated. Tune in to another
station providing the RDS signals. Flashes
Press to deactivate. Goes off Select “OFF” for the PTY code (see page 25)
to deactivate. Goes off
When driving in an area where FM reception is not
sufficient enough, this unit automatically tunes in to
another FM RDS station of the same network, possibly
broadcasting the same programme with stronger
signals (see the illustration on the right).
When shipped from the factory, Network-Tracking
Reception is activated.
To change the Network-Tracking Reception
setting, see “AF-REG” on page 25.
Tracing the same programme—Network-Tracking Reception
Programme A broadcasting on different frequency
areas (01 – 05)
Automatic station selection—Programme Search
Usually when you press the number buttons, the preset station is tuned in.
If the signals from the FM RDS preset station are not sufficient for good reception, this unit, using the AF data, tunes
in to another frequency broadcasting the same programme as the original preset station is broadcasting.
• The unit takes some time to tune in to another station using programme search.
• See also page 25.
EN06-13_DV4402_001A_f.indd 12 EN06-13_DV4402_001A_f.indd 12 12/12/07 11:56:46 AM 12/12/07 11:56:46 AM