JVC KW-NT30 - Manual (Page 9)

9
ENGLISH
Installation settings
When you turn on the unit for the first time, the initial
setup screen appears.
1
Turn on the ignition switch.
The power is turned on, and the startup screen is
displayed for about 5 seconds.
2
Select the language you want for the display
and the voice guidance.
• You can also select the system language through
the AV menu (<Settings> - <System> -
<Language>,
☞ page 68).
3
Display installation settings screen.
• If you select [Skip Installation Settings (for
Store Display)], the System starts in the store
display mode.
You need to make the installation settings next
time you turn on the power.
– When you turn on the power, <Select
Language> appears. After selecting
the language, the confirmation message
appears. Press [Yes] so that the System starts
initialization. When initialization is complete,
<Select Language> (
☞ Step 2 above) is
displayed.
4
Adjust the settings.
Country Select the country where you are
now.
Time Zone * Select your residential area for
automatic clock adjustment by
GPS signal.
Summer
time * Select <Auto> if your residential
area is subject to Summer time.
Reverse
Signal
Polarity * Select the reverse signal polarity
(<Battery> or <GND>)
according to the connection of
your car.
Camera
Input * Select <On> when connecting
the rear view camera to the
CAMERA IN jack.
* You can also change these settings through the AV
menu (<Settings>,
☞ page 68).
5
To cancel the display demonstration,
☞ page 67
(<Demonstration>).
EN_KW-NT30[E].indb 9 EN_KW-NT30[E].indb 9 3/10/2011 4:51:08 PM 3/10/2011 4:51:08 PM