JVC KD-DV7402 - Manual (Page 44)

ENGLISH
44
* If “Off” is selected in step 2 , you can only
adjust the subwoofer phase.
C Hi Pass (Hi Pass Filter)
Turn the control dial to select the cutoff
frequency to the front/rear speakers. Set this
to match the LPF setting.
• Off: All signals are sent to the front/rear
speakers.
• 62Hz: Frequencies lower than 62 Hz are
cut off.
• 95Hz: Frequencies lower than 95 Hz are
cut off.
• 135Hz: Frequencies lower than 135 Hz are
cut off.
D VolAdjust, [–5 to +5]
Turn the control dial to adjust the input level
of each source (except FM).
Adjust to match the input level of the FM
sound level.
• Before making an adjustment, select the
source you want to adjust.
E Loudness, [Off or On]
Turn the control dial to select “Off” or
“On.” When “On” is selected, low and high
frequencies sound are boosted to produce a
well-balanced sound at low volume level.
4
Exit from the setting.
Storing your own sound modes
You can adjust the sound modes and store your own
adjustments in memory.
• When
is shown on the display, you can
move back to the previous screen by pressing number
button 6.
1
2
Select a sound mode.
3
Select a frequency range to adjust.
4
Adjust the sound elements of the selected
frequency range.
1 Press
4
/
¢
to select the
frequency band, then press 5 / ∞ to
enhanced level for the selected frequency
band. [–6 to +6]
2 Press number button 5 ( ), then turn
the control dial to select the frequency.
3 Press number button 5 ( ), then turn
the control dial to select the quality slope (Q).
5
Repeat steps 3 and 4 to adjust the other
frequency bands.
6
Store the adjustments.
Preset value setting for each sound mode
Sound
mode
Preset value
Band 1 (100 Hz) Band 2 (320 Hz) Band 3 (1 kHz) Band 4
(3.2 kHz)
Band 5 (10 kHz)
USER 0 0 0 0 0
ROCK +3 +2 0 +1 +1
CLASSIC +2 +2 0 +1 0
POPS 0 +1 0 +1 +2
HIP HOP +4 +1 –2 0 +1
JAZZ +3 +2 +1 +2 +2
EN44-51_KD-DV7402_003A_5.indd 44 EN44-51_KD-DV7402_003A_5.indd 44 1/22/08 11:13:41 AM 1/22/08 11:13:41 AM