Plantronics Voyager 510-USB - Manual (Page 7)

0 0
To make a call, simply dial the number via your softphone application.
To answer or end a call, press the call control button.
When using PerSono Suite, the radio link between the headset and the USB Bluetooth
adapter will only be active during a call. This is the default setting intended to preserve
the battery life of the headset. However, you may wish to have the radio link active when
not on a call so you can listen to other audio sources, such as streaming audio on your PC.
NOTE: Locking the radio link on for extended periods of time will significantly reduce the
standby and talk time of the headset.
For softphones not compatible with PerSono Suite
Check the PerSono Suite compatibility list at www.plantronics.com/SoftphoneCompatibility
for the most current information on softphone compatibility.
If your softphone is not currently supported by PerSono Suite, remote detection and
answer/end via the headset does not function. Pressing the call control button on the
headset will only open and close the radio link providing audio; you must answer the call
from the softphone.
To answer or end a call, briefly press the call control button.
To make a call, enter number on your phone, press send and the call is automatically
transferred to headset; no need to press the call control button.
13 12
USING YOUR HEADSET
Additional features
Only with mobile phone
Answering/ending/making calls
with PerSono Suite on softphone
Redialling last number
To activate last number redial, double-
click the call control button. You will
hear a high tone for each key press.
When you hear a further tone, the last
number has been redialled.
Rejecting a call
When receiving an incoming call, press
and hold the call control button. You will
hear a tone. When you hear a second
tone, the call has been rejected and you
can release the button.
Using voice dialling
With the headset on, press and hold
the call control button for 2 seconds,
until you hear a second tone, to activate
voice dialling.
NOTE: To use voice activated dialling, the
voice dialling feature must be enabled on
your phone. See your Bluetooth phone
manual for instructions.
Switching a call from phone to headset
To switch an active call from your phone
to your headset, briefly press the call
control button.
Switching a call from headset to phone
To switch an active call from your
headset to your phone, press and hold
the call control button until you hear a
tone. When you hear a second tone, the
transfer has been completed and you can
release the button.
Answering/ending/making calls
with mobile phone
The Voyager 510-USB headset has Multipoint Technology which allows you to switch
seamlessly between two audio devices. You can answer a call from either your PC-based
softphone or your mobile phone by pressing the call control button. The headset must be
paired to both devices.
Multipoint versatility