Plantronics Savi Office WO350 - Manual (Page 17)

Plantronics Savi User Guide 17
Headset status Headset indicator light
Headset charging Off
Headset fully charged Off
Headset in-use Flashes green
Subscribing Solid green
Headset indicator light
toggling on/off headset in-use indicator light
If you are not on a call, you can toggle the headset in-use indica-
tor light on and off by pressing the headset volume down button
for three seconds.
Headset tones
Out of range warning
If you are on a call and go out of the operating range, you will
hear three low tones. You will hear a single mid tone when you are
back in range.
If you stay out of range, active calls will be suspended. Calls will
be re-established upon walking back into range. If you remain out
of range for more than 5 minutes the system will drop the call.
If you are not on a call and go out of the operating range and
press the call control button, you will hear a single tone for the
button press and three low tones for the failure to make a link.
Low battery warning
If you are on a call, you will hear a repeating single low tone every
15 seconds indicating the battery is low. You should recharge the
headset immediately.
If you are not on a call and press the call control button, you will
hear three lows tones indicating the battery is low. You should
recharge the headset immediately.
Mute warning
When mute is activated, you will hear three high tones. These
tones will repeat every 15 seconds while mute is active.
When unmuted you will hear three low tones.
Headset call control button functions
talk time
The Savi Office system will provide up to 8 hours of talk time. Talk
time will be reduced when operating in wideband mode and/or if
the headset is used consistently at a far distance from the base.
type of press Function
Short press Places, answers, or ends calls
Short press volume up Increases volume
Short press volume down Decreases volume
While in a link, long press
volume up (at least 1½
seconds) Switches between desk phone
and PC audio
Short press mute button Mutes or unmutes headset
While not in a link, long
press volume up (at least 1½
seconds) Places headset in subscription
mode
While not in a link, long press
volume down (at least 1½
seconds) Enables and disables headset
in-use indicator light
Placing the headset in sleep mode
If you won’t be using the headset for a long duration and the
headset will not be in the charge cradle, you can put the headset
in sleep mode by pressing the call control button for three sec-
onds while in an idle state. To exit sleep mode, press the headset
call control button again for three seconds.
Checking headset battery level
When the system is idle, short press the base subscription button
to check the headset battery level.
Headset battery
level PC talk button
indicator light Desk phone talk
button indicator light
75–100%
50–75%
25–50%
0–25% Solid green
Flashes green
Flashes yellow
Flashes red Solid green
Flashes green
Flashes yellow
Flashes red