CITIZEN SR-275EU - Manual (Page 4)

SR17D-D1-E.doc SIZE:140x75mm SCALE 2:1 2003/9/15
-E4-
Before starting calculation
„ Mode Selection
Each time [ MODE ] is pressed, various functions menus and all
argument values corresponding to the desired mode is shown on the
screen. It includes three calculation modes (COMP, SD, REG), three
angle units (DEG, RAD, GRAD), four display notations (FIX, SCI,
NORM, ENG) and reset function (RESET).
Entering an argument value can set up this calculator to operate as
you want it to. Give “SD“ as an example :
1. Press [ MODE ] once to display the calculation mode menu.
2. Enter [ 2 ] to let this calculator being operated under standard
deviation mode.
COMP SD REG
1 2 3
    → 
] 2 [
SD
0.
„
Using “2nd" keys
To execute the functions marked in yellow, please press [ 2nd ] and
then the corresponding key. When you press [ 2nd ], the
“2nd“ indicator shown in the display is to tell you that you will be
selecting the second function of the next key you press. If you press
[ 2nd ] by mistake, simply press [ 2nd ] again to remove the
“2nd“ indicator.
„
Cursor
Pressing [Ź] or [Ż] key can move the cursor to the left or the right.
Hold down any of those keys to move the cursor at high speed.
Pressing [ 2nd ] [Ÿ] or [ 2nd ] [ź] can scroll the display up or down
while there are previous entries hidden the display. You can reuse or
edit a previous entry when it is on the entry line.
„
Making corrections during input
To delete a character at the cursor, make the character underlined by
using [Ź] or [Ż] to move the cursor, and then press [ DEL ] to delete
the character.
To replace a character, make the character underlined by using [Ź]
or [Ż] to move the cursor, and then enter a new entry to replace the
character.
To insert a character, move the cursor to the position of the character
where you want to insert, it will be inserted in the front of the
character after pressing [ 2nd ] [ INS ] and entering a new character.
(Note) : The blinking cursor “ ” means the calculator is in insert
mode On the contrary, the blinking cursor is displayed as
“_” and it means the calculator is in overwrite mode.
To clear all characters, clear all input character by [ ON / AC ] key.