Candy AB CDC268TEX - Manual (Page 14)

To set the time delay option press and
release the ‘START DELAY’ button until
the required delay (shown in hours)
appears on the display and then press the
‘START’ button. The display will flash.
As each hour passes the figure shown on
the display will count down. When it gets
to 0 the dryer will start.
The delay can be changed at any time
simply by pressing the button until the
new figure appears on the display.
If there is an interruption to the electricity
supply the time delay will be lost and so
will have to be re-set when the power is
restored.
7. To switch off the buzzer, which sounds
at the end of each cycle, press the
‘ALARM OFF’ button.
8. The load is dried by tumbling in
thermostatically controlled warm air.
Cool air is used for the last 10 minutes
to reduce creasing and cool the load
ready for handling. During this time
the ‘COOLING’ indicator is lit.
9. When the program is fully completed
the drum will stop rotating. The dial
remains at the position of the selected
program. The ‘COOLING’ indicator
will flash and the buzzer will sound.
10. Open the door and remove the load.
If the load is not removed from the
dryer at the end of the drying cycle, a
‘creaseguard’ function is activated.
Every 15 minutes the dryer will tumble
the load for 5 seconds and the buzzer
will sound.
This process will be repeated until the
‘creaseguard’ function is cancelled by
opening the door
11. Clean the filter and empty the water
container after every drying cycle to
ensure maximum dryer efficiency. (See
‘Filter’ and ‘Water Container’
sections.)
12. Clean the condenser after
approximately every 10 drying cycles
to ensure maximum dryer efficiency.
(See ‘Condenser’ section.)
14
ENGLISH
WARNING!
THE DRUM, DOOR AND LOAD
MAY BE VERY HOT.
40000357-English.qxd 23-07-03 10:01 Page 9