Trouble shooting – Candy AB CDV 262 User Manual

Page 11

Advertising
background image

Trouble shooting

11

Trouble shooting

Should your dryer operate incorrectly,
check the following points before calling
for a service engineer.

Drying time is too long/clothes are not
dry enough:
● Have you selected the correct drying

time/programme? Go to page 7.

● Were the clothes too wet? Were the

clothes thoroughly wrung or spin-dried?

● Does the filter need cleaning? Go to

page 6.

● Is the dryer overloaded? Go to page 5.
● Is the venting hose kinked or blocked?

Go to page 4.

● Has the ‘HEAT SETTING’ option been

selected from a previous cycle? Go to
page 8.

The dryer does not operate:
● Is there a working electricity supply to

the dryer? Check using another
appliance such as a table lamp.

● Is the plug properly connected to the

mains supply?

● Is there a power failure?
● Has the fuse blown?
● Is the door fully closed? Go to page 9
● Is the dryer switched on, both at the

mains supply and at the machine? Go to
page 8.

● Has the drying time or the programme

been selected? Go to page 8.

● Has the machine been switched on again

after opening the door? Go to page 6.

The dryer is noisy
● Switch off the dryer and contact the

Hoover service number 08705 400 600
for advice.

Filter Care Indicator on:
● Does the filter need cleaning? Go to page

6.

● Is the venting hose kinked or blocked?

Go to page 4.

If the supply cord on this appliance is
damaged, it must be replaced by a special
cord which is only available from GIAS
Service or an authorised Dealer.

Should there still be a problem with your
dryer after completing all the recommended
checks, please call the national GIAS
Service number – 08705 400 600 – for
advice. They may be able to assist you over
the telephone or arrange for a suitable
appointment for an engineer to call under
the terms of your guarantee. However, a
charge may be made if any of the following
applies to your machine:

● Is found to be in working order.
● Has not been installed in accordance

with the installation instructions.

● Has been used incorrectly.

40000183.qxd 11/3/04 5:31 pm Page 11

Advertising