Candy CFU 1950 E - Manual (Page 4)

Well Ventilating
There is need of good ventilation around the appliance for easy dissipation of heat, high efficiency of refrigeration
and low power consumption. For this purpose, sufficient clear space should be need around the p r oduct . Its
back is at least 100mm away from the wall, its sides at least have a space of 100mm separately and the height
from over its top is not less than 200mm. A clear space should be left to open its doors to 160 °.
Power Supply
The product is only applied with power supply of single phase alternating current of (220-
240)V~/50Hz;230V~/60Hz. If fluctuation of voltage in the district user is of so large that the voltage exceeds the
above scope, for safety sake, be sure to apply a.c. automatic voltage regulator to the refrigerator. The appliance
must employ a special power socket instead of common one with other electric appliances. Its plug must match
the socket with ground wire.
Power Line Cord
The cord should be neither lengthened nor folded into coil during operation. Moreover, it is forbidden that cord
is kept close onto the compressor at the back of the p r oduct , the surface temperature of which is quite
high when operating. Touching with it would deactivatethe insulation or cause leakage for electricity.
Protection from Moisture
Avoiding placing the refrigerator in a place where heavy moisture is present so as to minimize possibility of rusty
for its metal parts. Still more, the refrigerator is forbidden to be directly sprayed by water, otherwise, poor insulation
and current leakage would occur.
Protection from Heat
The refrigerator should be far away from any heat source or direct sunshine.
2. CORRECTLY POSITIONING