Acclaim Lighting ART 9 - Manual (Page 5)

5. Color
Touch "C" key to enable Color Menu, the key clicks and the indicator lights up.
Then rotate the touch toggle to adjust the RGB value until you get the desired
color.
Up to 9 colors can be recorded in manual mode. Each figure key corresponds to
one color. The procedure to record a color is described below:
Touch "C" key to enable Manual Mode, the key clicks and the indicator is lit.
Repeat step a~d to save more colors to the other 8 figure keys.
All indicators flash momentarily once to indicate the current parameters,
including the value of color and brightness, have been saved into the key.
Touch any of the figure keys to which you wish to record the color, and hold
on for more than 2 seconds. c.
a.
Rotate the touch toggle to adjust RGB value until you get desired color. b.
d.
e.
Touch "C" key to enable Manual Mode. Then touch the corresponding button of
1~9 to raise the color which you've stored in the key. The LED indicator lights
up and it starts to display the recorded color.
5.1 Recording Color
5.2 Playback Color
5.3 Setting Fadetime for Color Exchange
Touch "C" key and hold on for 5 seconds till all LED indicators flash once.
Then release the key and the "C" key flashes repeatedly.
Different keys represent different fadetime. The table3 details the fadetime
information.
The existing mode ends and changes to normal mode automatically.
All indicators flash momentarily once to confirm the setting.
Touch any one of these keys--1, 2, 3, 4,5, 6, 7, 8, 9, P, C, B or S.
To set the fadetime for color exchange, you take the following procedures:
Operation Guide
Table 3
Page 6 ART-9 User Instruction
Keys
Fadetime
1 2 3 4
1s 2s 3s 4s
P/C/B/S
0s (no fade time)
5 6 7 8 9
5s 6s 7s 8s 9s
DMX OUT
PWM
O
UT
Made in P.R.C.
2A/CH.
6A
MAX.
GND
RoHS
DMX -
DMX +
GND
+12-24V
+12-24V
+12-24V
Blue
Green
Red
POWER IN
ART-9 features one group DMX OUT with 4-pin terminal connector, one group
POWER IN & PWM OUT with 6-pin terminal connector. The configuration of
the terminal is as the following(figure 2):
Figure 2
1 2
1. DMX OUT: 4-pin terminal
2. PWM OUT & POWER IN: 6-pin terminal
Page 3
Rear Panel View
ART-9 User Instruction