Remington IPL6000F - Manual (Page 15)

15
ENGLISH
The power switch is ON, but the unit is not working.
• Make sure the unit is plugged into a working electrical outlet.
• Try switching to a different outlet.
The unit appears to have cracks or is broken.
Do not use if the unit is damaged. If you have concerns about using the unit, discontinue use and contact
the Remington® Service Centre for further assistance.
, Frequently Asked Questions
I have switched the unit ON, but I cannot increase or decrease the energy level.
• Try resetting the unit by turning it off and waiting several seconds before turning it back on.
The Bulb Status Indicator Light turns green but the unit does not flash when the button
is pressed.
• Make sure the Skin Contact Sensor is in full contact with the skin.
• Try resetting the unit by turning it off and waiting several seconds before turning it back on.
There is a strange smell.
• Be sure the area is completely shaved before treatment.
The treated areas become red after treatment.
• This is normal and the redness should subside. If not, try using a lower energy level.
I have not seen optimal results or hair has begun to grow back.
• Hair may begin to grow back after your initial treatment. This is perfectly normal. For optimal results,
repeat the treatment when you notice hair regrowth.
Note: Do not treat the same area more than once a week.
F BE AWARE: If the unit is used over an extended period of time, the unit might
automatically disable momentarily (estimated 40 seconds) to cool down. Once the unit has cooled down,
it will be ready to use again.
GB
D
NL
F
E
I
DK
S
FIN
P
SK