Remington IPL6000F - Manual (Page 9)

9
ENGLISH
4. Place the skin of the intended treatment area onto the skin tone sensor - touching the skin tone
sensor (fig. 6).
If your skin is suitable, the appliance will beep and switch on.
If your skin is unsuitable, the appliance will buzz and remain off.
5. Test the i-Light device on a small patch of skin and wait 48 hours to ensure there are no adverse
reactions. (fig.7).
Fig. 5 Fig. 6 Fig. 7
, Treat desired area(s) with the i-Light device
Prepare your skin for treatment
1. Ensure the area to be treated is clean and free from oils, deodorants, perfume, make up, lotions and
creams. Shave or trim the hair from the area to be treated (fig 8).
2. Never use wax, epilation, tweezers or depilation products to remove the hair because they counteract
the IPL process.
Prepare the device for treatment
3. Unwrap the hand piece cord from the i-Light base and rest the hand piece in the base cradle. Locate
the power switch on the i-Light base and ensure the unit is OFF. Connect the power cord to the i-Light
base at the power inlet. Connect the power cord to the wall outlet. Turn the power switch ON. (fig. 9)
4. Use the skin sensor to unlock the unit (fig. 6).
You must unlock the unit on each body part you wish to treat.
5. Select the desired Energy Level. (fig. 10).
If your skin is unsuitable, the appliance will buzz and remain off.
GB
D
NL
F
E
I
DK
S
FIN
P
SK