Yukon PHOTON - Manual (Page 5)

5
BATTERY INSTALLATION
Turn the knob (2) of the battery compartment
cover 90° counterclockwise.
Remove the cover by raising it by its lug.
Slide in two АА batteries so that the “+” and “-”
match the polarity on the inner side of the cover;
rechargeable AA batteries may be used.
Close the cover of the battery compartment cover
and turn the knob (2) of the cover 90° clockwise.
Note: to ensure long and reliable operation it is
recommended that you use quality rechargeable
batteries with a capacity of at least 2500 mAh.
Please do not use batteries of different types or
batteries with various charge levels.
EXTERNAL POWER SUPPLY
The riflescope can be powered with an external DC power supply (2.1mm pin) with stabilised voltage ranging
from 8.4V to 15V or a 12V vehicle socket.
External power supply (AC/DC) is to be connected to “Power” (8) jack located on the right side of the
device.
Note: the central pin of the power supply that you connect to the “power” jack of the riflescope, must have
marking “+”.
The power supply may have marking -
Connection of an external power supply automatically cuts off power supply from batteries.
External power supply DOES NOT charge the batteries in the riflescope!
Attention! We suggest that you use battery packs EPS3 or EPS5 ensuring up to 40 hours of continuous
operation.
6
MOUNTING THE RIFLESCOPE
STARTING THE SCOPE AND IMAGE SETUP
Remove the cap (16) from the lens (14). The cap is outfitted with a light filter which reduces image brightness
in the daylight.
Turn on the riflescope by turning the wheel (9) clockwise until it clicks. A green LED indicator (3) will light up.
Important! When the indicator changes its colour to red, please replace the batteries.
Rotate the eyepiece adjustment ring (5) to see on the display a sharp image of the reticle.
Rotate the wheel (9) to adjust brightness: clockwise – to increase brightness; counterclockwise – to decrease
brightness.
To switch on the illuminated reticle, set the knob (7) against corresponding mark on the housing showing one
of the illumination levels (there are 11 levels). Reticle illumination is powered by a single CR2032 Lithium
battery. To replace the battery, unscrew the cover (6) of the knob counterclockwise and insert a new battery
with “+” facing upwards. Screw the cover.
To ensure precise shooting the sight should be correctly mounted on a rifle. Please follow these steps:
+
+
+
-
-
AA / 1.5 V AA / 1.5 V