Acnodes FES 2217 - Manual (Page 15)

2-3.3Jumper Settings
1. Clear CMONS Jumper (CLRCMOS1) [refer to P.14, No. 26]
It allows you to clear the data in CMONS. To clear and reset the system parameters to default
setup, please turn off the computer and unplug the power cord from the power supply. After
waiting for 15 seconds, use a jumper cap to short pin 2 and pin 3 on CLRCMOS1 for 5 seconds.
However, please do not clear the CMOS right after you update the BIOS. If you need to clear the
CMOS when you just finish updating the BIOS, you must boot up the system first, and then shut it
down before you do the clear-CMOS action. Please be noted that the password, date, time, user
default profile and MAC address will be cleared only if the CMOS battery is removed.
2. COM Port Signal/ Power Setting Jumpers (5-pin SET_CM1) [refer to P.14, No.3]
(5-pin SET_CM2) [refer to P.14, No.2]
(5-pin SET_CM3) [refer to P.14, No.41]
(5-pin SET_CM4) [refer to P.14, No.33]
(5-pin SET_CM5) [refer to P.14, No.34]
(5-pin SET_CM6) [refer to P.14, No.35]
3. Backlight Power Jumper (3-pin BKT_PWR1) [refer to P.14, No.7]