Acnodes PCH 3298 - Manual (Page 21)

PCH 3098
8 inch Atom Fanless Panel PC
© Copyright 2012 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com. 14628 Central Ave.
Chino, CA91710
Tel:909.597.7588, Fax:909.597.1939
15. FP1 : (2.0mm Pitch 2X5 Pin Header), Front panel connector.
Signal Name Pin# Pin# Signal Name
HD LED+ 1 2 POWER LED+
HD LED- 3 4 POWER LED-
Ground 5 6 PWR_ON
RESET+ 7 8 Ground
WAN LED- 9 10 WAN LED+
Pin1-3:
HDD LED, They are used to connect hard disk activity LED. The LED
blinks when the hard disk is reading or writing data.
Pin2-4:
POWER LED, They are used to connect power LED. W hen the system
is powered on or under S0/S1 state, the LED is normally on; when the
system is under S4/S5 state, the LED is off.
Pin5-6:
POWER on/off Button, They are used to connect power switch button.
The two pins are disconnected under normal condition. You may short
them temporarily to realize system startup & shutdown or awaken the
system from sleep state.
Pin7-8:
RESET Button, They are used to connect reset button. The two pins
are dis-connected under normal condition. You may short them
temporarily to realize system reset.
Pin9-10:
WAN LED, They are used to connect WAN LED.
Note:
When connecting LEDs, pay special attention to the signal polarity.
Make sure that the connector pins have a one-to-one
correspondence with chassis wiring, or it may cause boot up failure.