ACR&Artex RCL-300A - Manual (Page 11)

Y1-03-0232G 10

Press the Up or Down arrows to raise or lower the searchlight beam.
 To activate the XRCiZ™ feature, press and hold the ON/OFF button
for more than 5 seconds. The green LED indicates
that the XRCiZ™
feature is enabled.
 To deactivate the XRCiZ™ feature, press and hold the ON/OFF
button for more than 5 seconds. The red LED indicates that the
XRCiZ™ feature is disabled.
 An LED blinking red/green indicates that then XRCiZ™ feature is
now “exercising” the searchlight.

To activate the Self-
Park feature, press and hold the Point Pad™
Speed button for more than 5 seconds.

While the Self-Park feature is operating the searchlight, pressing any
Point Pad™ button will stop the park command and leave the
searchlight to follow any additional commands.

To deactivate the Self-
Park feature, press and hold the Point Pad™
Speed button for more than 5 seconds.

An LED blinking re/green indicates that the searchlight is seeking its
Self-Park position.

The Self-
Park and XRCiZ™ features are normally disabled when
power is lost to the URC-300 Master Controller and will have to be
reactivated.
NOTE: Self-
Park and the XRCiZ™ features are only available when
paired with a URC-300 Master Controller.
Figure 6