ACR&Artex RCL-300A - Manual (Page 5)

Y1-03-0232G 4
Figure 1- RCL-300A Components
SECTION 2 - SEARCHLIGHT MOUNTING
Make sure the area is clean and dry. The searchlight can be mounted
where desired, using appropriate length 5/16” diameter stainless steel
fasteners. One set is provided in the mounting kit and four (4) nylon
shoulder washers. The nylon washers prevent a galvanic reaction
between the mounting hardware and the base of the searchlight. Be
sure these washers have been inserted in the base mounting holes and
that the mounting base gasket is securely in place before bolting down.
Apply silicone grease to the bottom of the gasket to help in
waterproofing the unit. When mounting, be sure the searchlight is able
to rotate 360
° without hitting any obstructions. For the drilling hole
pattern, refer to the searchlight Mounting Template.
CAUTION: Do not mount the searchlight upside down. Moisture
cannot drain from the inverted light head assembly.
1
2
3
4
5