Acroprint MasterSync Wireless Synchronized Clock Systems - Manual (Page 2)

GPS Wireless Transmitter Set-up
Step 1- Screw transmitter antenna onto the back of transmitter. (Figure B)
Step 2 - Mount GPS Receiver to exterior of the building (see Mounting the
MasterSync
GPS Receiver below). Plug the GPS cable into the socket located
on the back of the transmitter.
Step 3 - Plug the 9 Volt 2.6 Amp DC power supply into the transmitter.
(Figure C)
(Figure A)
(Figure B)
(Figure C)
(Figure D)
(1)
(1)
(2)
TM
product manual -2
Step 4 - Plug the power supply into a 120 VAC outlet.
Step 5 - Confirm proper settings of time zone and frequency channel
and modify as needed.
Mounting the GPS Receiver
Connect the round GPS receiver onto the mounting plate
with the provided screw. (See Figure D) The GPS Receiver
should be located outside of the building, either roof mount
or side wall so it has a clear view of the sky with no overhanging
obstacles blocking its view. Run your GPS cable back to the
transmitter and insert end into GPS socket.
Power LED
The Power LED Indicator located on the front of the
transmitter will light up once you have connected the
power supply (provided) to the transmitter and then to
an active 120 VAC outlet. (Figure A)
TRANSMITTER DISPLAY:
1. DAY/MONTH/YEAR (Will automatically be set by GPS)
2. TIME ZONE (UTC OFFSET) (Factory Preset)
3. GPS INDICATOR (See GPS Communications section)
4. TIME (Will automatically be set by GPS)
5. AM/PM 12/24 HOUR INDICATOR (Factory set to 12 hour)
6. CHANNEL #
(Factory Preset)
7. DST (Daylight Savings Time) (Factory set to DST On)