Activeforever Forward Mobility Voyager Scooter - Manual (Page 3)

Step 7
Using the Voyager Seated Scooter® Brake and Brake Locking Pin:
Please note: the Voyager Seated Scooter® Brake is not intended for
use as the primary method to slow or stop the scooter, always use
your active foot to be the primary way to slow and stop the Voyager
Seated Scooter®.
Grasp the Brake Lever and squeeze to pull the
Brake Pad against the right rear Wheel to slow or stop the Voyager
Seated Scooter® (see arrow). Avoid excessive speed for your safety.
Always keep both hands on the Handlebar when the scooter is in use.
1. Note how the Brake Pad presses against the rear Wheel while
the Brake Lever is squeezed.
©2008-2009 FwdMobility All Rights Reserved
Step 2
The Voyager Seated Scooter® has two locking hinge posts; the
Seat Post and the Handlebar Post. Each hinge has two locking
components; the Locking Clamp and the spring-loaded Safety
Latch.
1. To lock the Handlebar Post in the upright position
Step 3
Make sure Handlebar Post is completely in the Lock Position:
The Brake Pad pushes against
the rear right Wheel when the
Brake Lever is squeezed.
Handlebar Post Locking
Clamp is pulled out and
down to allow hinge to
completely close as the
spring-loaded Safety
Latch is pulled toward the
rear and then clicks into
locking position.
Pull spring-loaded Safety
Latch head towards the
rear to allow hinge to
completely close. Notice
Safety Latch will move
into the locked position.
Spring-loaded Safety Latch is in
the locked position.
Locking Clamp head is completely
in the Hinge Slot.
Clamp Lever is tightened down
all the way. Check for looseness.