Activeforever Tek Partner Universal Big Button Remote Control (Tek Partner TV Remote Control) - Manual (Page 3)

USING POWER SCAN (SEARCHING)
At-A-Glance:
MODE (3 sec)
→ POWER → Blue ARROW UP( ) or Blue ARROW DOWN( ) → ENTER
If you cannot identify a correct Device Code for your equipment from the Device Code List,
you may try the POWER SCAN method.
1. Manually turn on the device you wish to scan for (e.g. TV)
2. Perform Power Scan by pressing and holding (approximately 3 seconds) the desired
DEVICE MODE button TV, VCR, CBL, DVD or SAT until the status indicator light begins
to blink.
3. Press and release the PWR (power) button. The status indicator light will stop blinking and
stay ON at this point.
4. Press and release slowly and patiently the blue UP ( ) button to scan forward through the
code database. To scan backward through the code database, press and release the blue
DOWN ( ) button. Each time you press the up or down arrow, the remote will try and turn
off the device (TV, VCR etc) you originally selected.
5. When the device (TV,VCR etc.) responds by shutting off, press the ENTER button. This will
store the code in memory and you will see three blinks of the status indicator light to
confirm the code input. Be patient, there are over 100 codes to search through.
NOTE:
■ Power Scan Model Check is the same as Power Scan, however, other keys may be tested to
see if they work with the target device without leaving the scan feature. If the device responds
to the other keys pressed, then the current ID will be locked in by pressing the ENTER button.
Otherwise, scanning may be continued by pressing either the blue ARROW UP ( ) or blue
ARROW DOWN( ) buttons.
At-A-Glance:
MODE (3 sec)
→ POWER → ARROW UP( ) or ARROW DOWN( ) → ANY VALID KEY
or (ARROW UP ( ) or ARROW DOWN ( ) ENTER
USING ID RECALL
At-A-Glance:
MODE (3 sec)
→ PREV CH
1. To see the Code of a device, press and hold the DEVICE MODE button (TV, VCR, CBL,
DVD or SAT) of the selected device until the status indicator begins to blink (approx. 3 sec-
onds).
2. Press the PREV CH button. Upon release of the PREV CH button, the status indicator will
blink the l00’s, l0’s and l’s of the device’s code.
3. Count the number of blinks to determine the code. A ‘0’ in any location is represented by a
fast flicker of the status indicator. An code of 102 will be shown as BLINK <pause> FLICKER
<pause> BLINK, BLINK .
SETTING PUNCH-THROUGH
At-A-Glance:
CBL or SAT MODE (3 sec)
→ CBL or SAT (hold) → TV
3
▲ ▼
▼
▼
▲
▲
▼
▲
▼
▲