Activeforever Tek Partner Universal Big Button Remote Control (Tek Partner TV Remote Control) - Manual (Page 4)

NOTE: By setting punch-through in CBL or SAT Mode, the TV’s volume up/down controls
will be accessed by the TEK PARTNER™ when in the CBL or SAT Mode.
1. Press and hold the CBL or SAT MODE button until the status indicator begins to blink
(approx. 3 sec.). Release the Device Mode button.
2. Press and hold the DEVICE button (CBL or SAT) and press the TV button. The status indi-
cator will blink a confirmation sequence of 2 blinks.
ENABLING MASTER POWER
At-A-Glance:
ANY DEVICE MODE (3 sec)
→ POWER → POWER
1. The Master Power feature is disabled as the default. To enable Master Power, press and hold
any DEVICE MODE button TV, VCR, CBL, DVD or SAT until the status indicator begins to
blink (approx. 3 sec.).
2. Press and release the PWR (power) button twice. The status indicator will blink a confirma-
tion (2 blinks) that Master Power has been enabled.
3. Repeat the process to disable the Master Power feature.
NOTE:
■ With Master Power enabled, the remote will send the power code plus 2 additional power
codes for each TV, VCR, CBL, DVD or SAT, in that order. All of the devices should be within
the remote’s operating range so they can receive their power code.
OPERATING THE TEK PARTNER™
Normal Operation Once you have set up the TEK PARTNER™ for your equipment, it works
like your original remote controls. To operate, just aim it at your equipment, press an appropri-
ate Device Mode Button and then command the desired function by pressing a corresponding
button on the TEK PARTNER™. The indicator turns on during signal transmission and as
confirmation of button touch. At your button touch, the TEK PARTNER™ illuminates the
keypad for 5 seconds. You will see the keypad clearly even when you are in a dimly lit area.
CARE & MAINTENANCE
1. Do not expose your TEK PARTNER™ to direct sunlight, high temperature, mechanical
shock, or liquids.
2. Do not use old and new batteries together as old batteries tend to leak.
3. Do not use corrosive or abrasive cleansers on your TEK PARTNER™.
4. Keep the unit dust free by wiping it with a soft, dry cloth.
5. Do not disassemble your TEK PARTNER™, it contains no user-serviceable parts.
4