Activeforever PAL 1000 Portable Aquatic Pool Lift - Manual (Page 8)

Unpacking Procedure for the PAL
1. Cut open the enclosure bag at the base of the unit and gently remove
plastic from unit.
2. Cut internal bands and remove chair assembly and housing.
3. Remove the accessory box and counterweight plate from the plate
enclosure.
4. Remove and unwrap the handle located under the frame.
5. Remove the main frame from the pallet. Position the main frame close to
the pallet and lock the wheels.
6. Carefully transfer the 16 remaining counterweight plates from the pallet
into the plate enclosure on the main frame. Each plate weighs approxi-
mately 40 pounds so be careful not to pinch fingers or drop when placing
into plate enclosure. Be sure that the plates lie flat on top of each other. If
any plate appears to rock, remove that plate, flip it over, and place it back
into the enclosure. On frame, remove twist-tie securing 24v motor cable,
position cable on top of counterweights.
7. Place housing on frame.
8. Remove 2 lock nuts and washers from mast mounting hub on base assembly.
9. Position mast assembly thru housing and attach to studs located on base
assembly with lock nuts and washers. Fully tighten with 3/4” socket
wrench.
10. Remove twist-tie and uncoil actuator cable at bottom of mast.
11. Lift and slide the housing part way up the mast to gain access to frame area
under housing.
12. Run actuator cable along with the 24v motor cable across the top of the
weights and insert through the hole in the rear of the housing near the
control box.
13. Insert actuator cable (with the “o” ring) into receptacle #1 on the control
box.
14. Insert 24v motor cable into receptacle #2 on control box. Make sure both
plugs are pushed in all the way.
15. Return housing to normal position and insert handle into slots.
16. Remove and unwrap hand control from accessory carton. Insert connector
into large receptacle on control unit and hang hand control on handle.
17. Attach battery to control unit mounted on housing.
18. Cover battery with furnished nylon material battery cover to protect
battery from moisture.
7