Activeforever Invacare Tracer Transport Wheelchair - Manual (Page 22)

SECTION 4—FRONT RIGGINGS
Transport Chairs 22 Part No.1125095
SECTION 4—FRONT RIGGINGS
ƽ WARNING
After any adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely. Otherwise, injury or damage may result.
Installing Swingaway Footrest Assembly
NOTE: For this procedure, refer to FIGURE 4.1.
1. Turn the footrest to the side (open footplate is perpendicular to transport chair).
2. Install the hinge plates on the footrest onto the hinge pins on the transport chair frame.
3. Push the footrest towards the inside of the transport chair until it locks into place.
NOTE: The footplate will be on the inside of the transport chair when locked in place.
4. Repeat this procedure for the other footrest assembly.
5. To release the footrest, push the footrest release lever inward, rotate the footrest
outward.
FIGURE 4.1 Installing Swingaway Footrest Assembly
Adjusting Footplate Height
NOTE: For this procedure, refer to FIGURE 4.2 on page 23.
1. Remove the swingaway footrest assembly. Refer to Installing Swingaway Footrest
Assembly on page 22.
NOTE: Lay the assembly on a flat surface to simplify this procedure.
2. Loosen, but DO NOT remove, the footplate mounting bolt until the footplate assembly
moves freely.
3. Reposition the footplate assembly to the desired height.
4. Securely tighten the footplate mounting bolt.
Footrest Release Lever
Hinge Pins
Hinge
Plates
Swingaway Footrest
Assembly