Activeforever Standers Mobility Bed Rail - Manual (Page 2)

Assembly Instructions
1. Remove all parts from the box and become
familiar with the parts as shown in Figure 1.
FIGURE 1
2. Determine which side of the bed the
product will be installed as shown in Figure 2.
FIGURE 2
3. IMPORTANT: Position the product in the
correct orientation based on which side of the
bed you will be using this product as shown in
Figure 3.
FIGURE 3
4. Connect Base Tubes together as shown in
Figure 4.
FIGURE 4
5. Attach Base Tubes into the Base Support
Tubes as shown in Figure 5. Make sure the
Spring Pins engage the hole in the Base
Support Tubes.
FIGURE 5
6. As shown in Figure 6, fully insert the
assembled product between the mattress and
box spring of the bed. Note that product
should be at least 18" away from the head of
the bed and the Handle should be 4" to 6"
above the top of the mattress.
FIGURE 6