Activeforever Standers Mobility Bed Rail - Manual (Page 3)

7. Adjusting height of Main Handle:
As shown in Figure 7, the height of the handle
can be adjusted up or down by loosening the
Collets by rotating counter clockwise. Depress
both spring pins so the handle can move up or
down to the desired height. After adjusting the
Main Handle to the desired height, tighten
Collets by rotating clockwise.
8. Adjusting height of Main Handle legs:
As shown in Figure 7, the Main Handle
Adjustment Legs can be adjusted up or down
to engage the floor by depressing the spring
pins so the legs can move up or down to the
desired height.
FIGURE 7
9. Adjusting height of Pivoting Handle:
As shown in Figure 8, the height of the Pivoting
Handle can be adjusted up or down by
loosening the Collet on the Pivoting Handle
assembly by rotating counter clockwise.
Depress the spring pin so the handle can move
up or down to the desired height. After
adjusting the Pivoting Handle to the desired
height, tighten Collets by rotating clockwise.
FIGURE 8
10. As shown in Figure 8, open the Velcro tab
on the side of the sewn organizer.
Position the Clamp Assembly against the
Pivoting Handle Assembly and tighten the
screw in the Clamp Assembly with the Allen
Wrench and then close the Velcro Tab.
NOTE: The Pivoting Handle Assembly must
be able to move upward approximately 1".
This will allow the user to lift the Pivoting
Handle Assembly to rotate it to different
positions.