Activeforever AXS Semi Portable Aquatic Pool Lift - Manual (Page 10)

10
OPERATING THE aXs
Follow these steps to operate the aXs:
• Rotate the seat to either side of the lift that is the most comfortable position
for transfer. The lift rotates 360º, so position the lift well over the pool deck
away from the edge of the pool.
• Adjust the height of the chair for a comfortable transfer.
• Transfer onto the seat and fasten the seat belt.
• Raise the seat so there is ample legroom for travel.
• Rotate the lift over the water and lower the seat into the water. The hand
control is waterproof, so keep it attached to the seat while swimming.
• Enjoy your swim.
• Following your swim, move back onto the seat and fasten the seat belt.
• Raise the lift out of the water and rotate the seat over the pool deck.
• Adjust the height of the chair for a comfortable transfer.
• Transfer off the lift.
EMERGENCY OPERATIONS
Although the electronic system used on the aXs is the same technology used on
thousands of lifting products throughout the world, there is always the unlikely
event that the product will not operate properly when needed. To anticipate any
mechanical failure, the following safeguards are engineered into the aXs:
Lifting failure: In the event of a lifting failure, there is an emergency capacitor
built into the control box to provide enough power to lift the seat out of the water.
Use a blunt object, like the cap of a ball point pen, to press the appropriate up or
down emergency button located above the LCD Display on the control box.
Turning failure: If the lift will not turn electronically, you can remove the
housing and pull out the spring pin located next to the turning motor. This will
disengage the gears and allow the lift to be turned manually.