Activeforever Teeter Hang Ups EP-550 Inversion Table - Manual (Page 9)

Step 5
Insert the Main Shaft (EP-1120) into the Table Bed (EP-1140)
• Loosen the De-rattler knob on the Main Shaft Housing.
• With the height adjustment settings on the Main Shaft facing up, slide the end of the Main Shaft into the Main Shaft
Housing on the Table Bed.
• Pull out the height-selector locking pin to allow the Main Shaft to slide in farther (Figure 10). For the purpose of
easy assembly, slide in the Main Shaft and release the pin in the last height setting (Refer to the Owner’s Manual
for proper height adjustment before use).
NOTE: The De-rattler knob is an optional accessory that helps prevent a slight shift in the table when you invert.
The security of the product is not compromised if you choose not to tighten the knob.
• The Main Shaft must rest against the Crossbar of the A-frame (Figure 11). The Crossbar prevents the table
from rotating forward when the user steps on the Foot Platform. If the Main Shaft does not rest on the Crossbar
as shown in Figure 11 then the Table Bed has been assembled backwards onto the A-frame and this must be
corrected before use.
Figure 10
De-rattler Knob
Main Shaft
Housing
Height-Selector
Locking Pin
Figure 11
Crossbar