Important notice, 24/7 support – AcuRite 01035 Weather Station User Manual

Page 16

Advertising
background image

CALIBRATION

TROUBLESHOOTING

Set Wireless I.D.

This wireless thermometer

uses long range 433mhz

radio frequency for

communication.

In the event that you have

reception problems due to

interference, both the main

unit and the wireless sensor

have a selectable wireless

ID. The ID switches are

located within the battery

compartments of the

display console and the

integrated wireless sensor.

You may choose A, B or C;

but both the main unit and

the wireless sensor ID's

must match for successful

synchronization.

A B C

Both wireless ID

switches

must match

A B C

press and HOLD all three buttons

for 15-20 seconds to calibrate

the calibration icon will

stay illuminated after

value is calibrated

CALIBRATING THE DISPLAY CONSOLE:

The integrated wireless sensor is designed and engineered to provide

accurate measurements, the internal fan aspiration ensures a proper

ambient air temperature in most cases.

If you feel that the placement or other environmental factors are

affecting the indoor or outdoor temperature or humidity readings,

the display console features a calibration feature for the indoor and

outdoor temperature and humidity. This allows you to adjust the

temperature or humidity reading up or down to compensate for the

affected reading.

CALIBRATION PROCESS:

1. Select the affected category (outdoor temp example shown here)

2. Press AND HOLD the “DOWN”, “SET”, and “UP” buttons at the

same time for 15-20 seconds.

• The display console will “BEEP”, and all information on the display

will disappear except for the value you are calibrating.

• You will note the “ ” (calibrate) and the adjust up and down

arrows next to the value you are calibrating.

3. Press the “UP” or “DOWN” arrows to calibrate the display

console reading up or down from the actual reading.

4. Press the “SET” button to confirm your calibration adjustment.

• Note that the calibration icon will stay illuminated next to all

calibrated values. This is done so that you know that the value has

been calibrated.

29

28

IMPORTANT NOTICE

Have questions about product setup or operation? We’re here to help!

EMAIL:

[email protected]

24/7 Support:

www.acurite.com

Product Setup & Demo Videos
Product Manuals
Frequently Asked Questions

Register your Product
Support Forum
Submit Feedback & Ideas

Don’t forget! Register your

product at:

www.acurite.com

TOLL FREE:

(877) 221-1252

7:00 a.m. - 7:00 p.m. CST

1-Year Warranty

Advertising