Using a sim card, Removing a sim card, Using a gps module (optional) – Acura Embedded AcuTab-M User Manual
Page 7
•
Keyboard
•
Mouse (for system software installation)
A keyboard is an input device; a mouse is a pointing device. Please connect these two
devices as graphics shown below to interact with your system.
Using a SIM Card
AcuTab-M can be equipped with a 3.5G module (optional) that can work with SIM card. (SIM
card is always working with 3.5G module.)
Inserting a SIM Card
To insert a SIM card into the SIM Card slot:
1. Turn off your System.
The AcuTab-M must be powered off while the SIM Card is being connected. Otherwise, it
is harmful to both devices and it shortens the life of these devices.
2. Unscrew the accessory cover on top of the Tablet PC.
3. Make sure the clipped corner facing inward with the gold fingers of the SIM card facing
down. Push the SIM Card firmly but slowly into the SIM Card slot.
To insert a SIM card into the slot, please pay attention only one correct side can be
accepted for the card slot. If you cannot insert the card into the slot or you had inserted
the card but it is not recognized by the AcuTab-M, please remove the card and insert it
again. To prevent the damage made both on card and the slot, never forced an entry into
the slot with incorrect side.
4. When the full length of the card is almost inside the slot, the SIM Card will be
automatically detected.
5. Place the accessory cover back and screw it firmly.
Removing a SIM Card
To remove a SIM Card from the SIM Card slot:
1. Turn off your system.
2. Slightly push the SIM card to pop it out and pull it out directly. When the SIM card has
moved out a space out of the slot, hold the edges of the card and slowly slide it out.
Using a GPS Module (optional)
AcuTab-M is designed with equipped the optional GPS module.
Before installing the GPS module, please adjust to DIP 2-3 for GPS mode as indicated in
the following diagram.
To install the GPS Module:
1. Make sure the system is turned off, internal battery detect DIP switch set to off and unplug
AC adapter.
2. Unscrew four screws from the accessory door on top of the system.
3. Mount and secure the GPS Tracker daughter board into the mainboard with screws.
GPS Tracker daughter Board
12
13