Acura 2010 MDX - Manual (Page 486)

BSI Status Displays
System
Status
Multi-information
display message
BSI Indicator Description
ON －
When you push the BSI OFF button, a BSI ON or OFF message is displayed on the multi-information
display for about 5 seconds.
The BSI indicator will remain on while the system is off.
A chime sounds to indicate that the system has been turned ON or OFF.
OFF
ON/OFF ꭧ
If while driving, mud, snow, or ice accumulates in the vicinity of sensor:
● The system may shut down
● The BSI indicator illuminates, a message is displayed on the multi-information display, and a chime
sounds.
The BSI indicator will turn off and the system will return to normal once the obstacle is removed, and
you begin to drive.
Always keep the area around the radar sensors clean. BSI may not operate properly if the sensors are
obstructed.
The BSI alert indicator:
● May come on when a vehicle enters one of the alert zones, even if this message is displayed.
● May not come on due to obstruction (splashes, etc.), even if this message is not displayed.
ꭧ: System status may remain on even when the BLIND SPOT NOT AVAILABLE message is
displayed.
OFF
If the system is faulty, the BSI indicator illuminates and a message is displayed on the multi-
information display.
Have your vehicle inspected by your Acura dealer.
CONTINUED
Blind Spot Information System (BSI)
479
Driving