Acura 2010 MDX - Manual (Page 58)

6. Attach the tether strap hook to the
tether anchor, then tighten the
strap as instructed by the child
seat maker.
If the tether strap is too long and
cannot be tightened firmly, find a
route where the strap can be
tightened securely.
7. Push and pull the child seat
forward and from side-to-side to
verify that it is secure.
Using the Center LATCH
To install a LATCH-compatible child
seat in the center seating position on
the second row seat, use the center
lower anchors as shown above.
1. Pull up the cover below the
armrest and find one of the
anchors. The other anchor is
located underneath the flap at the
bottom of the outer seat's inner
bolster.
2. Follow step 1 through 4 as
described previously to secure the
child seat.
3. Lower the head restraint first.
Route the tether strap over the
head restraint and seat-back, then
attach the tether strap hook to the
anchor, making sure the strap is
not twisted.
4. Push and pull the child seat
forward and from side-to-side to
verify that it is secure.
Installing a Child Seat
51
Driver
and
Passenger
Safety