Acura 2011 TL Navigation - Manual (Page 76)

Driving to Your Destination
Navigation System 75
Adding Waypoint
From the
MENU screen ( Route ),
if you say or select Waypoint , the
Add Waypoint screen is displayed.
Select either SEARCH AROUND
or SEARCH ALONG by rotating
Interface Dial knob .
Next, select the category from the
“Originals” or “My Favorites” tab on
the
Category screen, then follow the
menu prompts to select a destination.
When the system performs a search
from
SEARCH ALONG , it displays
matches that lie within a corridor on
either side and in front of your route.
From SEARCH AROUND , the system
displays matches that are a uniform
distance from the departure point/
waypoint/destination.
The search “corridor” distance value
can be changed in
Edit Waypoint
Search Area in SET UP (see page 108 ).
If you add a waypoint, the Dest List
screen will be displayed. If you move
the
Interface Dial down and select
OK , the addition is completed and
rerouting begins. Press the MAP/
GUIDE button to return to the map
screen without adding the waypoint.
To add another waypoint, press
the
MENU button and repeat the
procedure.
If Waypoint is grayed out, the
maximum of fi ve places (including the
destination) has been entered.
NOTE:
The system does not allow you to select
the roads you want to use to get to a
destination. However, after you enter a
destination, you can select intersections
or POI waypoints that the system will
use to tailor your route.
Back to Route
Returns you to the original
map screen.