Multi-view rear camera, P216) – Acura 2014 RDX Navigation User Manual

Page 217

Advertising
background image

216

Ot
her
Feat

ur

es

Multi-View Rear Camera

Your vehicle is equipped with a multi-view rear camera. When you shift into Reverse,
the rear view is displayed on the navigation system screen. The edge of the bumper
and parking guide lines are also displayed.

To turn the guide lines on or off, press
and hold the CANCEL button for
about three seconds.

Rotate

i to adjust the screen

brightness.

While the rear view is displayed, press

u to switch between WIDE, NORMAL,
and TOP DOWN view modes.

1

Multi-View Rear Camera

Always keep the camera lens clean and
unobstructed. The multi-view rear camera has a
lens that makes distances appear different than
they actually are. Always take care when
reversing, and look behind you for obstacles.

Navigation controls are disabled when in
Reverse.

Adjusting the brightness for the multi-view rear
camera display does not affect the brightness for
the navigation screen.

If you turn the guide lines off, they remain off
until you turn them back on.

The last used viewing mode is selected the next
time you shift into Reverse. However, once the
power mode is set to VEHICLE OFF (LOCK), WIDE
mode is selected if TOP DOWN view was last
used.

Multi-View
Rear Camera

Screen display

Bumper

Guide lines

Camera

Approx. 1 m (3.3 ft)

Approx. 2 m (6.6 ft)

Approx. 3 m (9.8 ft)

Approx. 50 cm
(1.7 ft)
Tailgate open range

Approx. 3 m (9.8 ft)

Approx. 2 m (6.6 ft)

Approx. 1 m (3.3 ft)

WIDE

NORMAL

TOP DOWN

QRG

2014 RDX

Advertising
This manual is related to the following products: