ACU-RITE ENC 150 (Old Style) - Manual (Page 8)

Mounting options can be adapted to machine mounting surfaces
using spacers, standoffs, or leveling set screws.
• Measuring length and mechanical configuration of your machine
determine your options.
• Backup spar mounting is an option but not required for lengths
up to 60”.
• Fastener lengths described on this page are included with the
encoder or the backup spar.
• Less than 24” : Use end mounting holes. • Over 60” : A backup spar is required.
7 ACU-RITE ®
ENC150 Mounting Requirements
1/4-20 x 1” BHCS
& scale washer
(supplied)
End hole mounting
1/4-20 x 1/2” BHCS
and spar washer
(supplied)
Backup spar
mounting
• 24” to 60” : Use end mounting holes with center support.
.94 [23.8]
1/4-20 x 1” BHCS
Typical (supplied)
1/4-20 x 3/4”
SHCS
Linear
Encoder
washer
Center
support
End hole mounting
with center support
M4 x 8mm
SHSS