Olympus FL-300R - Manual (Page 8)

10 EN
Shooting Shooting
According to the fl ash mode setting of the camera, shooting in TTL-AUTO mode or MANUAL
mode is available with this fl ash.
RC switch
1
Set the RC switch to “OFF”.
2
In accordance with the intended use, set the fl ash mode
of the camera.
For details, refer to the instruction manual of the camera.
MANUAL mode is not available for some cameras.
In TTL-AUTO mode: When fl ash activation has been performed correctly, the AUTO
CHECK lamp blinks for
about 5 seconds after the shooting.
In MANUAL mode: Adjust camera settings (ISO sensitivity and aperture value) based on the
distance to subject and then shoot.
Shooting distance (m) = Guide No. (ISO100) x ISO sensitivity coeffi cient ÷ Aperture value
Available shooting range (Table
P.4)
ISO sensitivity coeffi cient
ISO
sensitivity
25 50 100 200 400 800 1600 3200 6400
Coeffi cient 0.5 0.71 1.0 1.4 2.0 2.8 4.0 5.6 8.0
When using a fl ash, fl ash light may be blocked by the lens body, lens hood, etc.
When the shooting distance is closer to 1m, using the wide panel is recommended not to control the fl ash volume too much.
•
•
•
•