Garmin GNC 420 - Manual (Page 159)

GNC 420(A) Pilot’s Guide and Reference 9-11
SECTION 9
AUX PAGES
4) The flashing cursor moves to the type field
under the new message (Figure 9-27). Turn
the small right knob to display a window of
available options (Figure 9-28): Event, One
Time, Periodic. Press the ENT Key to select.
Figure 9-27 Type Field Highlighted
Figure 9-28 Type Window
5) The flashing cursor moves to the time/date
field. Use the small and large right knobs
to set the time or date required before the
message is displayed. Time is entered as
hours/minutes/seconds (hhh:mm:ss). Event-
based messages expire at a specific date and
time. Press the ENT Key when finished.
Editing a scheduled message:
1) Select ‘Scheduler’ from the Flight Planning Page,
using the steps described at the beginning of
this section.
2) The flashing cursor highlights the first message
field.
3) To edit the message text, turn the large right
knob to highlight the desired message field.
Use the small and large right knobs to edit the
message text—entering the new text directly
over the old message. Press the ENT Key when
finished.
4) To edit the time field, turn the large right
knob to highlight the field. Use the small and
large right knobs to edit the new date or
time—entering the new value directly over the
old figure. Press the ENT Key when finished.
Deleting a scheduled message:
1) Select ‘Scheduler’ from the Flight Planning Page,
using the steps described in this section.
2) The flashing cursor highlights the first message
field. Turn the large right knob to highlight
the desired message field.
3) Press the CLR Key to delete the message
text, followed by the ENT Key to confirm the
deletion.
190-00140-20 Rev. K