Garmin G1000 Quest Kodiak - Manual (Page 74)

Garmin G1000 Pilot’s Guide for the Quest KODIAK 100 190-00590-03 Rev. A 62
FLIGHT INSTRUMENTS
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO P
ANEL
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL FEA
TURES
APPENDICES
INDEX
When a bearing pointer is displayed, the associated information window is also displayed. The Bearing
Information windows (Figure 2-20) are displayed at the lower sides of the HSI and give the following
information:
• Bearing source (NAV, GPS)
• Pointer icon (BRG1 = single line, BRG2 = double line)
• Station/waypoint identifier (NAV, GPS)
• GPS-derived great circle distance to bearing
source
• Frequency (NAV)
When the NAV radio is tuned to an ILS frequency the bearing source and the bearing pointer is removed
from the HSI. When NAV1 or NAV2 is the selected bearing source, the frequency is replaced by the station
identifier when the station is within range. If GPS is the bearing source, the active waypoint identifier is
displayed instead of a frequency.
The bearing pointer is removed from the HSI and NO DATA is displayed in the information window if
the NAV radio is not receiving a VOR station or if GPS is the bearing source and an active waypoint is not
selected.
Selecting bearing display and changing sources:
1) Press the PFD Softkey.
2) Press a BRG Softkey to display the desired bearing pointer and information window with a NAV source.
3) Press the BRG Softkey again to change the bearing source to GPS.
4) To remove the bearing pointer and information window, press the BRG Softkey again.