Garmin GPS 12CX - Manual (Page 59)

51
Proximity Wpt can’t be Deleted – The waypoint you are trying to
delete is listed as a proximity waypoint and must be removed from the
list before it can be deleted.
Read Only Mem has Failed – The permanent memory has failed and
the unit is not operable.
Received an Invalid WPT – A waypoint was received during upload
transfer that has an invalid identifier.
Receiver has Failed – A failure in receiver hardware has been detected.
If this message persists, do not use the unit and take it to an authorized
dealer for repair.
Route is Full – You have attempted to add more than 30 waypoints to
a route.
Route is not Empty – You have attempted to copy into a route already
in use.
Route Waypoint was Deleted – A route waypoint entered does not exist
in the database and has been deleted from the route.
RTCM Input has Failed – DGPS data being received has been lost. You
are no longer receiving the beacon signal.
Searching the Sky – The GPS 12CX is in searching the sky for almanac
data or the unit is in AutoLocate™ mode.
Stored Data was Lost – All waypoints, routes, time and almanac data
has been lost due to battery failure or clearing the receiver’s memory.
Track Memory is Full – All track log points in memory have been used.
You must either delete the current tracklog or switch the record option to
‘WRAP’ which will begin erasing the oldest tracklog points as new ones
are added.
Transfer has been Completed – The receiver is finished uploading or
downloading information to the connected device.
WPT Memory is Full – You have used all 1000 waypoints in the GPS
12CX. Delete unwanted waypoints to make room for new entries.
APPENDIX C
Messages