Garmin StreetPilot III - Manual (Page 67)

65
No Diff GPS Position – No differential correction data is available or not enough data is available to
compute a DGPS position.
None Found – A search through MapSource data, using the selected criteria, has produced no matching
results.
Processor Failed – The unit has detected a fault in its internal processor. If this message persists, the unit
is unusable - return it to Garmin for service.
Route Memory is Full – Route memory is full and no more routes can be saved or added (from another
GPS unit or a PC).
Route Truncated – The route has been truncated because it was too long. There will be turns missing
prior to the destination.
Route Waypoint Memory is Full – There is no more space for map-based route waypoints (used for
turns).
Safe Mode is Turned On – The action attempted is disabled while moving to prevent distractions from
driving.
Sunrise, Switching to Day Mode – The map is switching to the Day Mode display.
Sunset, Switching to Night Mode – The map is switching to the Night Mode display.
That Route Name is Already Used – The route name you have entered is already being used by another
route.
This Route Does Not Match the Available Maps – The route was planned on maps that are not currently
installed.
This Route Has an Unknown Format – The route contains unexpected data.
This Route Has Consecutive Via Points – The StreetPilot III only allows two consecutive user-specifi ed
via points if there are roads between these via points.
This Route Has Too Many Via Points – The route entered contains too many via points (intermediate
destinations) and can only be navigated in an off-road, or point-to-point fashion. Note that the StreetPilot III
only supports up to 100 user-specifi ed via points.
Appendix H
Messages
190-00256-10_0B.indd 65 1/13/2003, 10:34:35 AM