Garmin GPSMAP 130 - Manual (Page 83)

Poor GPS Coverage—The GPSMAP 130 cannot acquire the necessary num-
ber of satellites to compute a position.
Power Down and Re-init—The GPSMAP 130 cannot calculate a position due
to abnormal satellite conditions. Power down and verify the last position
shown by other means.
Proximity Alarm—You have entered the alarm radius for the proximity way-
point indicated.
Proximity List Full—You have used all nine proximity waypoints.
Proximity Overlaps Another Prox Wypt—The alarm radius specified over-
laps the area specified for another proximity waypoint. (See section 10 for more
information on proximity overlaps.)
RAM has Failed—The random access memory has failed and the unit is not
operable. Take your unit to an authorized GARMIN service center for repairs.
ROM has Failed—The unit’s permanent memory has failed and the unit is not
operable. Take your unit to an authorized GARMIN service center for repairs.
Received Invalid Waypoint—A waypoint was received during upload trans-
fer that has an invalid identifier.
Receiver has Failed—A failure in receiver hardware has been detected. If this
message persists, do not use the unit and take it to an authorized dealer for
repair.
Route Already Exists—The route number you are trying to copy to is already
used.
Route Does Not Exist—The route number you are trying to use or copy is
not defined.
Route is Full—You have attempted to add more than 30 waypoints to a route.
Route Memory is Full—You have attempted to create more than 20 routes.
Route Waypoint was Deleted—A route waypoint entered does not exist in
the database and has been deleted from the route.
RTCM Input has Failed—DGPS data being received has been lost. You are
no longer receiving the beacon signal.
Searching the Sky—The GPSMAP 130 is searching the sky for almanac data.
Stored Data was Lost—All waypoints, routes and almanac data has been lost
due to internal battery failure.
There is No RTCM Input—The beacon receiver is not properly connected or
baud rates do not match.
Timer Has Expired—The countdown timer has expired.
Track Memory is Full—The track memory is full and no additional track plot
will be recorded until the track memory has been cleared or set to wrap mode.
Wypt Already Exists—The waypoint name you’ve entered already exists in
memory.
Waypoint Memory is Full—You have used all 250 waypoints in the GPSMAP
130 system.
73
SECTION
C
APPENDIX
Messages
gps 130 7/23/98 9:23 AM Page 73