Bosch GCM 12 JL Professional - Manual (Page 28)

28 | English
1 619 929 L91 | (6.8.12) Bosch Power Tools
Symbols
The following symbols can be important for the operation of
your power tool. Please memorise the symbols and their
meanings. The correct interpretation of the symbols helps
you operate the power tool better and more secure.
Symbols and their meaning
f Laser radiation
Do not view directly with optical in-
struments
Class 1M laser product
f Keep hands away from the cutting
area while the machine is running.
Danger of injury when coming in con-
tact with the saw blade.
f Wear a dust respirator.
f Wear safety goggles.
f Wear ear protectors. Exposure to
noise can cause hearing loss.
f Danger area! Keep hands, fingers or
arms away from this area.
Observe the dimensions of the saw blade.
The hole diameter must match the tool
spindle without play. Do not use reducers
or adapters.
Do not dispose of power tools into house-
hold waste!
Only for EC countries:
According to the European Guideline
2002/96/EC for Waste Electrical and
Electronic Equipment and its implementa-
tion into national right, power tools that
are no longer usable must be collected
separately and disposed of in an environ-
mentally correct manner.
f Always adjust the saw-ta-
ble extensions properly
in order to underlay or
support long workpieces
at their free end. Work-
pieces that are not suffi-
ciently underlaid can tilt or
tip over during sawing. This
can lead to injury or dam-
age the power tool.
f Always saw with the dis-
tance-stops inserted.
Without distance-stops,
the contact surface is too
small and the workpiece
cannot be sufficiently se-
cured for sawing.
In order to saw workpieces higher than
75 mm, the distance-stops must be in-
serted at the front position on both sides.
The distance-stops always must be in line
to each other, so that a straight contact
surface for the workpiece is achieved.
Symbols and their meaning
100x100mm
OBJ_BUCH-1600-002.book Page 28 Monday, August 6, 2012 3:36 PM