ARIETE MVC2 Deluxe 4210 5 - Manual (Page 20)

18
GB
• Do not leave the iron unattended.
• Always disconnect the iron’s connecting plug (30) from the machine and the machine’s power supply
plug (36) when not in use.
• During use, rest the iron on the iron rest (38) provided.
• Do not use the iron if any breakage or malfunction is noted.
• Take it to an ARIETE Authorised Assistance Centre for all maintenance operations, including replace-
ment of the inter-connecting cable.
Instructions for using the iron:
BEFORE INSERTING OR REMOVING THE IRON FROM THE APPLIANCE BODY (6) SWITCH OFF THE
APPLIANCE USING THE RELEVANT SWITCH AND UNPLUG IT FROM THE MAINS ELECTRICITY BEFO-
RE ALL OPERATIONS.
- Before inserting the plug of the connecting cord (36) into the
appliance inlet, open the hatch (31) and press lightly on the tabs
at the end of the plug, as illustrated in figure T. After this, insert
the connector as illustrated in figure R (for Mod. 4210/2 irons)
or in figure S (for Mod. 4210/5 irons).
- Insert the connector plug of the iron into the socket of the machi-
ne.
Plug the power supply cable into the mains and operate switch (5) to iron with steam.
If you wish to iron without steam, do not switch on the boiler.
- Set the temperature adjustment thermostat (35) according to the
type of fabric to be ironed.
IMPORTANT!
When it is necessary to iron articles made from different types of
fabric, divide them into groups and start by ironing those which
require the lowest temperature.
- The vertical steam facility allows hanging garments and curtains
to by ironed perfectly and with ease.
- To obtain a supply of steam it is only necessary to operate one
of the steam switches located on the iron (34 intermittent steam,
33 continuous steam).
CAUTION!
At the start of each ironing session, it is possible that drops of water may come from the holes in the plate.
This is due to the condensation of steam as it passes through the tube. To avoid this happening, just ope-
rate the steam button until the droplets stop being emitted, holding the iron well away from the articles
to be ironed.
- At the end of a steam ironing session, it is possible to expel any steam remaining in the boiler by tur-
ning the steam adjustment knob (35) anti-clockwise to the “MAX” position and continue pressing the
switch on the iron until all the steam has been used up.
Fig. R
Fig. T
Fig. S
2_interno_GB 3-06-2004 8:58 Pagina 18