EVS MulticamLSM Version 10.04 - January 2011 Configuration Manual - Manual (Page 36)

Issue
10.04.A
EVS Multicam – Version 10.04 – Configuration Manual
EVS Broadcast Equipment SA – January 2011
28
The settings are described in the table below:
Setting Description
VarID The VarID parameters will be set up differently depending on the
protocol used.
Uniqueness
This setting specifies whether the VarID will be unique at the
XNet network level (Global) of at the XT level (Local).
The default value is ‘Local’.
Length This setting specifies whether the VarID has a fixed length of 8
bytes or a variable length of 32 bytes.
The default value is ‘variable 32 bytes
Format This setting specifies whether the VarID format has the ASCII or
binary format. The default value is ‘ASCII’ as specified for VDCP
standard.
Protocol
Visibility
The protocol visibility allows specifying the list of servers which
will be visible on the various communication ports the protocol will
communicate with.
For a list of servers, use the XNet number of the server and semi-
colon separator (;). If no value is specified, the default is the
local server.
Example: 8;2;3;9
The list order is taken into account in the protocol visibility. This
means that the system first searches for the requested clips on
the first server of the list, then on the second, and so on.
In the above-mentioned example, If a clip with the same identifier
is found on server 8 and server 2, the system would choose the
clip on server 8 should this clip ID be loaded and/or modified.
Delete
Strategy
No Delete Strategy is applied to this version.
By default, the deletion applies to the first visible clip only.