EVS Xsquare Version 2.1 User Manual - Manual (Page 55)

Automatic Value for EVS Server Source
If the EVS Server Source Selection setting is set to Automatic in the underlying job
template, Xsquare will select the source as follows:
1. If Xsquare cannot connect to the MTPC board of the EVS server, Xsquare will
define the clip source as Intra, and look for an Intra clip.
If no Intra clip exists, the job will fail (even if an XDCAM clip exists).
2. If Xsquare can connect to the MTPC board of the EVS server and the job is a
grab, the engine will use in priority the Intra clip as the source:
Available source on the EVS
server
Codec used as source
Intra + XDCAM Intra
XDCAM only XDCAM
Intra only Intra
3. If Xsquare can connect to the MTPC board of the EVS server and the job is any
other process (copy, rewrap, restore, transcoding action, referencing in an NLE,
etc.), the engine will use in priority the XDCAM clip as the source:
Available source on the EVS
server
Codec used as source
Intra + XDCAM XDCAM
XDCAM only XDCAM
Intra only Intra
3.3. Icons Manager
The Icons Manager window makes it possible to store the icons you want to associate to
the job template in order to symbolize the job destination.
The windows are displayed in the upper part of the window, and the buttons to add ,
remove , import or export the icons are displayed at the bottom of the window.
Once your icons are imported, they will all be available in the job template definition, via
the Destination Icons field.
USER MANUAL Xsquare 2.1
3. Configuration 49