EVS XEDIO CleanEdit Version 4.35 - August 2013 User Manual - Manual (Page 175)

• The Paste action resets and removes all existing effects already applied to the
destination clips.
How to Copy a Video Effect
To copy a video effect, proceed as follows:
1. Select the clip with the already configured effects
2. Right-click to open the contextual menu
3. Select Copy Clip FX.
How to Paste a Video Effect
To paste these copied video effects, proceed as follows:
1. Select the clip you want to apply the copied effects to or set a mark IN and mark OUT
points to cover the clips to which the effects should be pasted.
2. Right-click to open the contextual menu
3. Select Paste Clip FX.
8.4. Conversion Effects
8.4.1. Introduction
Each clip can be converted by the software in Xedio CleanEdit to match the format that
the timeline is using. Conversion can be from and to 4:3 and 16:9 with Pan & Scan and
Letterbox modes supported.
When you have created the Edit, you have selected the aspect ratio for the edit (or it was
non-editable, as for 16:9 with HD video standards). Depending on the aspect ratio for the
edit, you have selected a default conversion type.
You can change the mode used for the selected conversion type (for example PS, instead
of the default conversion type which was LB), by adding a conversion effects to a clip or to
several clips between a mark IN and mark OUT. You will not be able to change the
conversion type itself since it is set at the beginning and has to remain unchanged in the
whole edit.
USER MANUAL Xedio 4.35 Xedio CleanEdit
8. Advanced Video Editing 159